Features
This pump is the world's first pump which is used in mass-produced watercooled workstations and is ideal for water cooling of processors and suitable electronic components. Due to its size and output can also be used in a variety of applications.
This DC pump is an electronically commutated motor pump, with running times of well over 50,000 hours at 12 volts. The only moving part in a spherical motor pump is a spherically shaped rotor / impeller, which is supported on an ultra-hard, wear-resistant ceramics bearing ball. A conventional shaft with shaft bearings and shaft seals does not exist.
The spherical bearing of the rotor / impeller on the ceramics bearing ball provides a variety of advantages: a development of clearance - and thus a noise increase - is not possible in principle. The pump is so quiet about the entire term.
The bearing is self-adjusting. It is lubricated directly by the delivery medium (wet-running pump). No maintenance is undertaken. Since the rotor is always held magnetically in the intended position, smaller dirt particles represent no problem, a blockage of the pump is usually not possible.
Even after a long period is given a safe start. Is driven by the permanent magnetic rotor / impeller unit of a magnetic field generated by the surrounding stator. This is built entirely around the rotor. The entire pump is thus with 38 mm only slightly higher than the stator itself so that it fits easily into all conventional PC, Barebone and Mini PC cases. A separate magnetic shielding is usually not necessary.
The ball motor principle enables an economical enterprise with comparatively high performances. be controlled by varying the voltage DDC DC pump can be easily and over a wide power range. All wetted parts are corrosion resistant.
Technical Data:
-
Dimensions: (WxLxH) 62x62x38mm (without connections)
-
Motor type: Electronically commutated spherical motor
-
Rated power consumption: 18 Watt
-
Rated voltage: 12 V DC voltage
-
Perm. Voltage range 6 to 13.2 volts
-
Head at 12V: 4,7 m
-
Max. Flow rate: 600L / h
-
Fluids: water
-
Max System Temperature: 60 ° C
-
Wetted parts: stainless steel 1.4571, PPS-GF40, EPDM O-rings,
-
Aluminum oxide, hard coal
-
Connections: 2x G1 / 4 "male
Delivery:
-
Laing DDC-Pump 12V DDC-1RT Plus 2xG1/4-Außengewinde
-
Our advice: take the 1 / 4 inch sockets (mounted with Teflon tape) and then normal G1/4
Pumps speedometer: With 3-pin Molex connector as pump pulse output (for mainboard or control units)
Note: The pump is the latest revision.
Important: We recommend the use of schmierfähigem addition of water (such as AT Protect Plus or Innovatek Protect). Anti-Corro-Fluid is not recommended.
Attention: Due to the power of the pump may min with only one cycle. 1 cooler will be operated. When operating without load can blow the pump. Important: The Laing pump's electronics are not waterproof. Please make sure that the electronic components Do Come not in contact with water during installation or when working on the pump. When replacing the top always Ensure a proper fit of the O-ring seal and avoid spills when filling the reservoir Laing. Damages due to water in the electronic components are not replaced by Laing!